how to install your units decals

Things to remember when applying your UNITS decals

1. Watch the video as it gives you a good place to start. Do not remove the entire decal backing and try to put it on the container. You can create a sticky mess as the static attraction of the material will cause it to stick to itself and it is difficult to apply.

2. This decal material has an industrial adhesive that is not very re-positional....when it is stuck to the container it is very difficult to pull it up and reposition it without damaging the decal. So do your best to make sure it in the position you want when you place it on the container.

3. The decal has “grooves” on the bottom so any large air bubbles will work their way out with the roller and squeegee. Take your time and you will have good results.

4. Make sure the surface is clean and dry.  Some 409 works great in cleaning the surface of the container and dries quickly.

5.  Start with about 2” of exposed decal when you put it on the container.  Work slowly and use the roller as you are removing the backing paper.  Remember the air bubbles will work their way out of the material.

6. Do not apply your decals when it is over 85 degrees or the containers are “too hot to touch.”  The decal material is a type of vinyl and the excessive heat can cause the decal to stretch or not stick correctly.  If you are in a hot climate, apply the decals in the morning.

7.  If you do get a tiny wrinkle in the decal that will not come out, remember that the container is normally viewed from 5 or more feet away and that wrinkle may not be noticeable.

8. When the decal is applied and you are “done” with the application, give it one last check to make sure all the edges are nice and flat. A raised edge could let water under the decal and cause it to fail over time.

9.  If you make a mistake and have to remove the decal, we always include a few extra just in case you need to try it again .